Beyond Better
saltare inverts
Senior Member
Find latest postsMini Statistics
- Join Date
- 02-20-2009
- Last Activity
- 06-02-2011 04:26 PM
- Avatar
More 12 Friends
Recent Visitors
- etegoNeex,
- jasun,
- Jetlink,
- LakeAustinRiverboat,
- Lance,
- MDVols,
- NCSaltare,
- skiman_61,
- SteveMildred,
- swey
- Tab Content
- saltare inverts's Activity
- Visitor Messages
- About Me
- Friends
- Tab Content
-
Older Activity
-
05-16-2013, 11:18 AMTrailer looks brand new! Why does your tower always look crooked to me? Is it slightly askew?34 replies | 946 view(s) -
05-16-2013, 11:17 AMYou sure you have all of the bolts out? Sounds like something is still attached. Keep in mind that this has been wet/moist and sitting for a long...26 replies | 349 view(s)
-
05-16-2013, 11:15 AMStarting to really come together!100 replies | 6380 view(s)
-
05-16-2013, 11:15 AMYou could also try the hot wrench. A little flame would probably separate them right off.6 replies | 73 view(s)
-
05-16-2013, 11:12 AMFor the water, there is a few different options. Most prefer that the engine "suck" in water, rather than have a hose "push" it in. I don't think...5 replies | 87 view(s)
-
05-15-2013, 05:50 PMThe red wire going to the starter solenoid is connected to the key and engages the starter when you turn it. Do you still have the original...10 replies | 98 view(s)
-
05-15-2013, 02:15 PMYour method will work but it's going to be hard work. Get some hull cleaner (or muriatic acid -- same thing but a lot cheaper). Spray on, brush,...15 replies | 269 view(s)
-
05-15-2013, 12:33 PMIf you melted the negative side of the battery, you have a short some where. Check for continuity between + on the battery and ground. Clean and...10 replies | 98 view(s)
-
05-15-2013, 12:31 PMMy dripless collar actually has 2 allen set screws with 2 additional allen set screws holding those in. Need to take out the outermost set to get to...26 replies | 349 view(s)
-
05-14-2013, 04:05 PMHis Vinyl lady isn't going to have Pantone 403/404 vinyl -- she's going to have a black and maybe a couple of shades of grey. Sign vinyl has a...28 replies | 451 view(s)
-
05-14-2013, 11:09 AMLOL -- Pretty sure he meant he couldn't see the stripe because there wasn't enough contrast. I'd look into the costs of these before you get too...28 replies | 451 view(s)
-
05-13-2013, 11:21 AMFirst things first -- we need to find out if you're actually over heating. The gauges rarely go bad and the fact that you're this close to "normal"...9 replies | 116 view(s)
-
05-13-2013, 12:07 AMYou should replace the rear main while it's apart. It's easy and cheap preventative maintenance. You can use the regular auto one.26 replies | 349 view(s)
-
05-09-2013, 04:21 PMYou're going to paint that bilge.... right?? ;)100 replies | 6380 view(s)
-
05-09-2013, 04:20 PMYou can check the timing at any RPM and it will give you some indication if you are super far off. I'd just play with it and see if it makes it...13 replies | 152 view(s)
-
05-09-2013, 02:26 PMHonestly, this sounds like a timing issue to me. Dieing @ 2000rpms means either fuel starvation or timing. You need a timing light to check and see...13 replies | 152 view(s)
-
05-09-2013, 10:25 AMYou can also take an old bicycle inner tube and make some additional "shims." Rubber cement will double those things up forever.4 replies | 99 view(s)
-
05-09-2013, 10:25 AMwotan2525 replied to a thread 1986 Supra Sunsport w/ tower bimini and new stringers in Supra ClassifiedsLooks like it's in nice shape. Is this a boat that we've seen before? Looks familiar to me....6 replies | 186 view(s)
-
05-09-2013, 10:23 AMDoes it have good gas? Sounds like just a hard cold start at this point... Have you tried a shot of starting fluid? Electric or mechanical...13 replies | 152 view(s)
-
05-08-2013, 10:29 AMJust when I thought I was happy with my cover.... HangTyte comes along.5 replies | 154 view(s)
-
05-07-2013, 03:09 PMI think the price on this boat is reasonable. Good luck with the sale!10 replies | 303 view(s)
-
05-06-2013, 04:12 PMOh also - I needed the rub rail AND the insert. If you are only replacing the insert, it's probably a lot cheaper.4 replies | 86 view(s)
-
05-06-2013, 11:10 AMI just told Jim @ Viper that I wanted it and he shipped it to me. Here's from my emails to him (he never said how much I purchased, but I do...4 replies | 86 view(s)
-
05-06-2013, 11:05 AMI've always had good luck with the db electrical stuff. Usually cheaper than the rebuild that I can get locally....11 replies | 195 view(s)
-
05-04-2013, 12:27 AMLet's go 3k USD and 4k CAN..... She needs stringers but has Had a sugar daddy lover for I can't even remember 4-5 yrs??? August '08 I think is when I...3 replies | 122 view(s) -
05-03-2013, 11:24 PMI'm about to cheat on my beloved BFG family, 3 sets oF tires, long trail, rugged trail, and all T's in that order 2 diff vehicles, after my Canuck...14 replies | 279 view(s)
-
05-03-2013, 11:09 PMMahogany trim??? Oh boy....10 replies | 303 view(s)
-
05-03-2013, 10:45 PMJust puttin out the feeler's, any interest in a'90 conbrio north of the lower 48 pre restoration???3 replies | 122 view(s)
-
05-03-2013, 02:17 PMThe NAPA part number is FIL 3225 and is always in stock around me.....1 replies | 54 view(s)
-
05-03-2013, 11:35 AMCan you make two? My boat has never had one. :(9 replies | 153 view(s)
61 Visitor Messages
About saltare inverts
Basic Information
About saltare inverts
- Location:
- Missouri
- Interests:
- Wakeboarding, weightlifting
- Occupation:
- General Contractor
Signature
Statistics
Total Posts
- Total Posts
- 932
- Posts Per Day
- 0.60
Visitor Messages
- Total Messages
- 61
- Most Recent Message
- 08-26-2010 11:59 PM
General Information
- Last Activity
- 06-02-2011 04:26 PM
- Join Date
- 02-20-2009
- Referrals
- 0
12 Friends
Showing Friends 1 to 10 of 12
© 2013 Supra Boats | All Rights Reserved