Beyond Better
Ptownkid
Senior Member
Find latest postsMini Statistics
- Join Date
- 06-06-2010
- Last Activity
- Today 12:07 PM
- Avatar
1 Groups
Join Groups 0 Permission Groups
You are not a member of any groups
Recent Visitors
This page has had 2,001 visits
- Tab Content
- Ptownkid's Activity
- About Me
- Friends
-
Older Activity
-
Today, 02:54 PMI know it's not what you want to hear, but I think you can buy them one at a time from Skidim. For a $$$$$$$ of course.4 replies | 16 view(s) -
Today, 02:53 PMIn prison, that's considered a marriage proposal.25 replies | 1375 view(s)
-
Today, 12:52 PMIt cracked more as they didn't heat it right before brazing and it cracked? Or it was already cracked? I'd be checking their process before "I"...4 replies | 16 view(s)
-
Today, 09:05 AMAre you talking about the two vents right below the windshield? They run down into the bilge right below the captains helm and spotter seat. They...25 replies | 1375 view(s)
-
Today, 08:31 AMCheck the hardness of the casing on the cables. By bending them they should feel plyable and no cracking internally. If so replace them. I have seen...3 replies | 37 view(s) -
Today, 08:26 AMAnother saved from death.... Looks great and enjoy the beautiful scenery of your back yard for us. I see someone is extra ready to get out there and...33 replies | 1146 view(s)
-
Today, 08:12 AMIf you can get a tight seal around the inlet of the shop vac I might even let it run longer than a few hours. I would also assume the port side is...8 replies | 141 view(s)
-
Yesterday, 10:22 PMI know some others looking at this boat and were told it had overheated pretty bad once, and possibly could have had new heads installed. Do your...1 replies | 49 view(s)
-
Yesterday, 09:56 PMFunny how a math exam became a Calculus one with a quick swoop of the mouse:)19 replies | 142 view(s)
-
Yesterday, 09:51 PM+1 on this.19 replies | 346 view(s)
-
Yesterday, 09:49 PMI thought the loading of the ballast tanks was impressive. For anyone who is doing a stringer replacement right now this would be a great addition to...11 replies | 184 view(s)
-
Yesterday, 09:46 PMFound a link for a owners manual.. http://www.ufpnet.com/Portals/0/PDFs/A-60,%2075%20_%2084%20Actuator%20Maintenance.pdf2 replies | 24 view(s)
-
Yesterday, 09:15 PMPolished the boat using a foam 3000 grit pad from 3m, followed with a compound/polish in one. Wow what a finish on the gel coat. Took about 4hours to...2 replies | 24 view(s)
-
Yesterday, 09:13 PMWas pulling my Launch from the house using the Jeep TJ. When unhooking forgot about the break away cable which was attached to the Jeep when I drove...2 replies | 24 view(s)
-
Yesterday, 08:08 PMSissies.19 replies | 142 view(s)
-
Yesterday, 04:38 PMPersonally I like just the wave better. It was a bit big though. Good color though, matched well.19 replies | 346 view(s)
-
Yesterday, 04:37 PMIf all else fails, measure the tank and do the math. :D Y'all remember that right? The stuff your teacher said you'd have use someday. Well here it...19 replies | 142 view(s)
-
Yesterday, 02:05 PMThe reason I asked is I can't really see how it's mounted. All I can see is what looks to be like it's sandwiched in between the platform and the...17 replies | 225 view(s)
-
Yesterday, 10:51 AMThat looks nice and clean. I've seen those "ram mounts" before, but can't figure out where. What are they normally used for? I'm not going to...7 replies | 172 view(s)
-
Yesterday, 10:49 AMWhat sarcasm? I was dead serious and curious about your mounting system. I had real fears that if not properly mounted you'd tear your swim...17 replies | 225 view(s)
-
Yesterday, 09:22 AMNot a Supra but mighty impressive. http://www.youtube.com/watch?v=CF9_-q4TbF811 replies | 184 view(s)
-
Yesterday, 06:46 AMThey should be available at any dealer that sells control cables...4 replies | 76 view(s)
-
06-17-2013, 09:33 PMDefinitely my favorite of the newer composite boats. Love the color. Great looking setup.3 replies | 88 view(s)
-
06-17-2013, 08:37 PMJust an idea but what about a shop vac ?? Drill a 3/4" or so hole into the floor under the seat in the rear section of the boat to expose the foam....8 replies | 141 view(s)
-
06-17-2013, 08:33 PMYou're on the site that will have it. Click here: http://www.supraboats.com/downloads/ Go to owners manuals, select the 1989 Comp. It will be...1 replies | 32 view(s)
-
06-17-2013, 05:24 PMThis is not meant to be rude...but there's a search box on the upper right hand side of the page that will give you all the answers you could ask...4 replies | 41 view(s)
-
06-17-2013, 05:00 PMEveryone has covered everything, I just wanted to say Holy Crap that boat looks great on the outside. Get the interior done right, and polish up...24 replies | 605 view(s)
-
06-17-2013, 01:40 PMYou will be back in the water in no time. As for the stringer question... Solid factory ones are getting more and more few and far in between. There...24 replies | 605 view(s)
-
06-17-2013, 01:32 PM5 gallons on a empty tank is more like 2 when you consider the shape of the fuel cell. I always leave shore full so there is always more than enough...8 replies | 132 view(s)
-
06-17-2013, 10:41 AMWhat is holding it in place? Please tell me it's not the swim platform.17 replies | 225 view(s)
About Ptownkid
Basic Information
About Ptownkid
- Location:
- Ontario, Canada
Statistics
Total Posts
- Total Posts
- 836
- Posts Per Day
- 0.75
General Information
- Last Activity
- Today 12:07 PM
- Join Date
- 06-06-2010
- Referrals
- 0
© 2013 Supra Boats | All Rights Reserved