Search:

When was the last time you replaced the impeller? If it has run dry for any length of time you will fry it. Sounds like it needs to be replaced. Make sure all your intake clamps are tight, and check...

looking sharp , now i'll know what to do in the future

You didn't have to take it all apart to repack it, are you changing to a dripless? Although you might as well replace your strut bushing now while your at it . Once you freed the coupler the shaft...

Awesome diy job, very cool

It means they reuse the antifreeze on an on going basis and test it coming out the exhaust on i/o , o/b, and i/b as they winterize.All good shops do this , maybe even lower depending on latitude, as...

curious as to how you winterized your motor?

ok , fix the hose and see if there is a problem......keep it simple......you need to fix the problem then see if it caused another issue......watch your gauges and see if it overheats, check your...

I hope nothing cracked. No antifreeze will enter the block until the thermostat opens. All the antifreeze will bypass the engine and out the exhaust. You have to have an external recirculating system...

with the bolts loosened just bump the motor over .....usu enough to loosen the bond. if its been that long you may want to remove bolts completely and refrsh the mating surfaces to remove any...

Mine are located on the port side at the rear of the stern storage compartment..........as with all S.C. boats.......now saying this, maybe they did this to even out the driver side weight issue ,...

what he ^^^^^^^^ said

wow , i hope the water isn't up to the electrical....shocking experience

shell rotella 15 40, mobile1 filters are what I use, Dexron III or compatible for the tranny and sae 30 for the vdrive.......its not rocket science. assuming your post 1999 engine...jmo

Check out the moomba forum how to , same motors and part numbers are listed in a specs thread

I'm curious as to where you are placing the dial indicator. I can see this telling you if your shaft is bent but I'm trying to figure out how you can get a proper mating between the shaft and...

its a 20 min procedure to check and 60min to dial it in to .002. search the moomba forum for how to pics and instructions. Do it once and your a pro at it. Some wrenches, feeler gauge, and a crowbar...

Water levels are about 2 ft down from high level but are norm for this time of year so as not to cause dock damage. Once the ice is gone they will throw a few logs on the dam and have the level up to...

This is similar to the Binford 2013MSD that Tim Allen has promoted. Red Green tried to get the patent but masking tape instead of duct tape was used in the patent papers and he was denied.

looks great, cant wait to find out how it performs for you

It wasn't that the hinges were to weak. There were not enough of them and the divider would bow into the engine compartment between them. The use of 3 hinges would solve the problem although if they...

Nice pics, welcome to the forum

There used to be size limits and I imagine there still are. It tells you in some area that I cannot recall at this moment

A 2" trailer coupler is nice to have as well.

Once you start reaching or exceeding max specs on trailers or any axels the biggest concern is hitting pot holes or bumps at speed. The forces put on the stress bearing components are of major...

Oh , yes one of many..........can you say 1981.......