So I did one section with several steps to see what it looks like. I realize I'm not going 100% with the steps and not taking it all the way, but I'm not liking what I'm seeing. It would be hard to see in pictures, but I will say the haze is most noticeable right above where the stripes were removed. I'm sure that's due to being light handed with it before. The section I did was with 600, 800, 1000, compound (by hand) and then I looked at it. It seems that haze is still there to an extent. Should I consider doing 600 with a electric or air palm sander and do it dry? Should I step up to 320 and stay wet? Thoughts?